Separate names with a comma.
I'm using another string for the loop, and used a slippery string... Also it's possible to pull it at an angle. You're also pulling max 20 cm, so...
42 minus 10, because you need to weave the loops as well... ;)
I tried this one. Using threads I could not get it to work. Because of the tighter spacing of the mains the thread would no pull through easily,...
Racket survived the session, but it did feel too heavy. Side-disbalance was no issue. Don't know if it was always this head heavy, will weigh the...
Tried the repair V2 on my armortec500... Made a mistake though, I did not let the glue harden before putting the frame on the pins. So perhaps the...
Everybody thanks for their reaction, but this is not a thread about hitting another racket. Yes, I do hit another racket sometimes (most of the...
It's strung at 21-22lbs. I don't think clashes can be avoided 100%, and all my others rackets have survived them pretty well (I have a hard clash...
I will try method 2 with my armortec500 and arcsaber11. Will use 2 component epoxy glue (Bison and steel rivets
I play 2~3 times a week and do not often break records (used my ArmorTec 500 for 6 years) but ofcourse do have a occasional racket collission with...
Which method do you prefer ?
I find it kind of ironic I have never needed an awl anymore after reading your suggestions and seeing your videos, whereas you're still using them ;)
Never use an awl or a hook (anymore). Always cut the string in a tip, look through the hole to see in which direction I should put it in (Kwun's...
I agree, sometimes it's unavoidable, but I do always check to see if passing an outer string under or above is working best. At the bottom...
I've had some success with using stencil ink to "glue" the cross and mains together. I've had one player break strings much quicker than all my...
When I started stringing I used a string mover, currently, never... Just cutter, pliers and 2 yonex flying clamps. Never used an awl during...
I first bought a grommet remover [ATTACH] maybe I'm using it wrong, but I found it to be severely lacking, then I bought [ATTACH] and this works...
Not to mention that the previous string will have kinks all over the place where it needed to make sharp turns on the grommets... Pretty sure you...
Once I tried white logo on black string (request of the owner) but the white ink didn't work at all. In the end I used black ink on almost the...
I think so too (hidden in a lot of other text), but it's always possible to overlook a grommet (and just focus on the shared holes). Asking for a...