Hey Guys, I just received my Pro's Pro shuttle express today and strung a racket on it. This is my first time using a 6 pint machine and I had some questions regarding all of the supports. It seems like the 12' and 6' supports are a bit too far away to fit a badminton racket. I had to loosen the two supports to the point where the knob was only halfway on the bolt to even fit my PPPP on it. I had wanted to use a load spreader, but with how much I had to loosen the supports on the machine, I don't think I'll have enough room without the 12 o'clock support coming undone. Also, the side supports seem to dip a little bit when fully relaxed. When i bring them inward to hold the racket in place, they rise to the correct level of the frame. Is this normal? Additionally, one of the side arms is about 1mm too low and I have to push the arm upwards a bit while bringing it in to line it up with the racket frame. Is this normal of the Pro's Pro shuttle express?