Results 1 to 3 of 3
08-21-2012, 10:19 AM #1
stringing carlon racket with razor gated technology
I bought 2 monts ago a carlton prototype v1.1 but the string was terible.
So i wanted to restring it and removed the string of the frame. And i fixed the racket frame in my stringing machine to re-sting it. but i could not re-string it because it is a strange patern.
So my question is have someone expirience with stringing a carlton Razor or prototype ?
Or have someone a stringing patern for those rackets?
08-22-2012, 02:05 AM #2
Zoom to it
Seems they are using single-piece method bottom-up. The bottom cross string is 8, the bottom tie-off is on 7th main.
The top tie off is a bit hard to find - it is on the 8th main between the last two top crosses on the left.
I think the crosses must be started the one way only - this cannot be seen from the picture - I think you need to calculate it by yourself.
So put the racket in the machine as it is on the picture and make sure:
mains short end has tie off on the left
the first weave of the bottom cross is correct
Hope this helps
08-22-2012, 02:41 AM #3
thanks for u awnser.
meanwhile i was been able to string the racket by a regular 2 string patern.
But i hope the string will have a long life time.