Results 1 to 6 of 6
11-03-2012, 03:55 PM #1
Tension head on stringing machine super sensitive
I've recently started restringing again using my Pro's Pro Comet 1 crank machine and have come across a problem with the tension head on the machine. Basically the spring-loaded part which releases when the set tension has been pulled has become extremely sensitive and will release at random times, so I have to be really really careful when pulling tension. I've attached a photo of the area in question--I think the reason why it's suddenly doing this is because the metal of the part has worn down over time.
I don't know if I've described the problem very well, but if anyone has any ideas on how to fix it I would be very grateful!
11-03-2012, 04:47 PM #2
A small hex screw is located at opposite side of the trigger will fix the issue. But this will increase the tension, because this is the screw use to adjust the tension, so a tension calibrate is need for this adjustment. Also an other smaller hex screw on the side has to loose before can turn the first one.
11-03-2012, 05:14 PM #3
Thanks so much. I thought it would be something to do with this. Not quite sure how to go about it though. Seeing as the this is the screw used to adjust the tension, how would i re-calibrate the machine to display the correct tension?
11-03-2012, 06:42 PM #4
You need a calibrator, preferable a digital one, as reference, set you machine tension to 25 pounds, attach the calibrator on a fix point on the turntable, them pull, if the tension display on the calibrator go over, them turn the adjustment screw in to decrease the tension. Otherwise, turn the screw out to increase the tension.
11-04-2012, 07:23 AM #5
Right, but when I turn the screw in, I'll just be back to my original problem?
11-11-2012, 07:05 AM #6