Thread: String tension for AT 500
01-02-2005, 08:02 AM #1
String tension for AT 500
What is better tension for AT 500
I love this racket and i don't want to break it
01-02-2005, 08:05 AM #2
Normally, people use from 15-25. Professional player might use 25-30+.
It depends on your skills and strings you are using.
01-02-2005, 08:22 AM #3
if you looking for better tension then better stick with the factory requirements
i got one AT500 myself, usually string it with BG66 at 27lb(note:Brunei's system is still uncertain, so from the last time we managed to calculate out this value), it is roughly at that value for my AT
and that was after two clashes which killed one high-end racquet(MP100) and a low-end gosen...
04-27-2007, 03:28 AM #4
strung AT500 at 24lb. i got PERFECT balance between power and control. Use bg85 for my AT500 4UG5
04-27-2007, 03:56 PM #5
I use an armortec 500 and it is currently strung it at 21lbs with bg-65. i love this racquet can control all my nets and drops very well. however when i first got this racquet i used bg-68 ti at 23 lbs i found that the smashes were a lot better but my nets and drops were about the same.
04-27-2007, 04:15 PM #6
hmmm, i use a 3ug5 at500 and i find bg65 @ 27 lbs is great for power and control
By mat21 in forum Badminton Rackets / EquipmentReplies: 11: 01-13-2012, 01:25 AM
By dawei94 in forum Badminton Stringing Techniques & ToolsReplies: 20: 11-14-2009, 12:35 AM
By jeffproX in forum Badminton StringReplies: 10: 01-27-2008, 08:09 AM
By bz123 in forum Badminton Rackets / EquipmentReplies: 6: 12-07-2007, 04:28 PM