2 Knot Stringing Method

[Wonderland]

Thank you guys...been great help...
I will try to use 2 knot method once at least
but how long will the "short side" be? around 275cm??

[silentheart]

Thank you guys...been great help...
I will try to use 2 knot method once at least
but how long will the "short side" be? around 275cm??

275cm should be ok for the main short side. For your problem on the fitting 2 strings through 1 hole, I use un-waxed dental floss to guide the string through the hole with a string in already. First, you need a floss > 10cm. Insert both ends of the floss through the target hold. Pull the floss out by both ends untill it forms a loop about 1 cm in radious. Use the floss as a needle and insert a shout end of the string through the loop and pull the floss through the hole. The string will come through with the floss. You know the rest... I hope this will help.

[Alexccs]

Thx

I am using EAGNAS Smart 808 right now....I know how to do the 4 knot stringing method......I want to learn it because some sotx racket really don't support with the 4 knot stringing method...the last finish hole suppose to be 6th one..but it only can fit one string path...

You are right. Sotx Woven 4A has grommet for double strings pass only on 8T, 9T, 10T and 12T. (T=throat)
With 4 knot, after both 8T used, you have to finish at 10T (that is how my original strings come with). I recommend you to use 2 knot method on Woven 4A.
Note, Grommet 8T, 9T, 10T and 12T so big can pass 3 strings without any problem. Even BG-43 or BG-63.

[LazyBuddy]

Note, Grommet 8T, 9T, 10T and 12T so big can pass 3 strings without any problem. Even BG-43 or BG-63.

If that's the case, then share 1 of the 8T with 3 string should be a valid choice.

[Benasp]

today i had nothing to do and i decider to become a stringer for fun so i cutted of te string of a old racquet and made a plan, dunno if it's good but it work i need to find a string machine to tension taht but the shape is good, i will try to explain, i don't know if this method is good i doesn't even know how to tension a racquet

Armortec 700 ( 72 hole)



1- pass about 6 inch of the string in the 7th grommet from the shaft attach it to the shaft just for security

2- enter the string in the 12th grommet and make it continue to the 26th, make a it return in the next on (27)

3- very important when you come back to the buttom, don't put it in the next hole but pass one so it will enter in the 10th grommet

knot 1-when you are at the 7th grommet you can make the knot on the string

4- follow the arrow until 12th in the other side and make it goes to the 8th grommet on the same side, continue to make the cross following the arrow.

5- at the top make the knot following the arrow that make a round with two round.

i dunno if we can make the first knot before tensioning but i don't see any trouble doing that

[Benasp]

and hey

yellow mean one string make that loop

pink mean two string pass these grommey