Custom Design Stringing Machine from Eagnas

[ryeung]

Wow, that sounds quite a job. Please take photos for us .

Master Dan doesn't have the shortening and widening problem as you described. Did you mount the side supports correctly? Are the side supports in contact with the frame square on without any space?

As far as I can tell the side supports are right. I do not use the pins but rather a large washer and bolt. I initially loosen the supports, bring the side arms close and bring the supports to the frame and tighten. Do that for all 4. Then I give the adjustment knobs about an eighth of a turn.

I will try to remember to take some pics the next time I need to restring. Probably not for another couple of weeks or so. Or I can just mount a racket and show the set up.

[ryeung]

Wow, that sounds quite a job. Please take photos for us .

Master Dan doesn't have the shortening and widening problem as you described. Did you mount the side supports correctly? Are the side supports in contact with the frame square on without any space?

here are some pics