Thread: Solution To High Noon Desease
04-16-2007, 09:36 PM #1
Solution To High Noon Desease
There seems to be many ppl in CA and USA sufferred from this problem.
There is a simple solution.
When you string, put an additional rubber supporter at the top supporter.
This can diversify the stress and prevent the problem.
As to where to buy the rubber supporter, don't ask me.
I don't know.
Ask stringing machine dealers might be good.
04-16-2007, 10:00 PM #2
Load spreaders does the job.
People can get Yonex and Gosen loadspreaders from shuttle-house.com
High-noon disease is mostly a six-point suspension machine issue.
Originally Posted by foo.tw
Last edited by Pete LSD; 04-16-2007 at 10:03 PM.
04-16-2007, 10:10 PM #3
HeHeHe, Here's the causes and the solution :-
Cause 1: String crosses Top to Bottom
Solution : String Crosees Bottom to Top
Cause 2 : Strecthing the frame length
Solution : don't / Not much.
Can't remember anything else. hehe
04-17-2007, 07:23 AM #4Originally Posted by Pete LSD
04-17-2007, 09:57 AM #5
if the side, throat & head supports are over tightened, it can just as easily lead to stress at the top and bottom of the frame.
04-29-2007, 07:33 PM #6
well i just use the grip and folded to little pad and taped to the 2-point support. I helps me string 25lbs+ with no problem.
I'm thought this is a 2-point system problem, because cause the two supports stop the frame from shortening when stringing the vertical.
04-29-2007, 11:03 PM #7
tried that, do not work
my 9000x still cracks
i shall try and get a little piece of lather and place it on the rubber
By llpjlau in forum GripReplies: 11: 01-25-2007, 01:10 AM
By ants in forum Racket Recommendation / ComparisonReplies: 9: 11-01-2003, 10:10 PM
By ants in forum General ForumReplies: 9: 11-01-2003, 10:10 PM
By Phil in forum ShuttlecockReplies: 2: 03-02-2003, 04:44 PM
By Wedge in forum General ForumReplies: 4: 05-21-2001, 12:28 PM