Results 1 to 17 of 21
Thread: Behold the POWER BULGE grip
11-04-2009, 07:18 PM #1
Behold the POWER BULGE grip
Anyone else do this or is it just me?
I've taken the factory grip off, added a small section of overgrip in the centre of the handle, and then put a Karakal U Super over the lot.
I'm even considering making an injection molded Kraton rubber tapered tube that you can put on and then wrap over the top.
11-04-2009, 10:18 PM #2
The problem is that it interfered with changing hand position quickly...
This bulge works for singles players but not so good for doubles...
11-05-2009, 12:52 AM #3
Meh, works great for me for both, no problems moving my hand around for various shots.
Biggest improvement for me is the accuracy of my overhead shots has improved with this grip [drives, smashes] because I have a more positive grip on the handle.
I say give it a go!
11-05-2009, 01:14 AM #4
you put on the grip yourself ?
man, you sure know how to put on a grip, the finishing is so nice
11-05-2009, 02:14 AM #5
Pre wrap (before you pull off the protective cover on the tape) and cut off the excess from the square end...
Now start wrapping from the square end, NOT from the end that says START...
This way You will have a nice tapered end for the finish......
Another thing is the more you over lap the grip the fatter it is....
If you want thinner handle size stretch the grip while putting it on and do not over lap it....
11-05-2009, 03:03 AM #6
please, I don't need instructions on how to put grip on.
Go critique Taufik.
11-05-2009, 07:30 AM #7
11-05-2009, 02:39 PM #8
When you grip something, the effectiveness of how you grip it is how much of the surface area of your palm is able to exert an even force on the grip. When you make a fist, the interior of your hand is not a tube or a hexagon, so therefore pressure on the grip will not be even.
I find that the slight bulge in the middle helps me with control - especially in drives and smashes - because I'm not just relying on primarily my fingers to give me directional and rotational stability of the racket.
It doesn't effect changes in hand position either. I can still just as easily move my hand down for serves or use more of a fingers grip for defensive net play.
11-05-2009, 07:16 PM #9
I do something similar but my "bulge" is on the entire higher half of the grip. So I get a thinner grip at the bottom for better power and full swings (near base), and a fatter upper half for better control shots and tighter flicks (everywhere else).
Like you, my bulge is created with a layer of used overgrip under my overgrip. This has the advantage of
- better standardisation whenever the overgrip is changed;
- allow the overgrip to actually reach over the cone (my pref). You are using karakal so you have enough length anyway; and
- looks neater with a uniform overlap across the entire handle.
11-05-2009, 07:17 PM #10
11-05-2009, 09:50 PM #11
11-05-2009, 10:22 PM #12
I don't have a chip on my shoulder AT ALL.
What I do have an issue with is you mistaking this thread for a "How to wrap your grip like me in case it was too much of a mental challenge for you" thread.
And I reiterate to the resident smart-arses - Would you tell Taufik or LD that their wraping style was not up to your 'professional' level of aesthetics or neatness or whatever. No, you wouldn't. So you can extend me the same courtesy.
If you want to start up your own "how to wrap your grip like a 'pro' ", be my guest.
Last edited by Easy Tiger; 11-05-2009 at 10:35 PM.
11-05-2009, 10:28 PM #13
11-05-2009, 10:34 PM #14
Also, I bet he has to regrip so many of his rackets so often that he just doesn't care to make it all nice anymore.
11-05-2009, 10:48 PM #15
LD and Taufik's grip styles are too thin for me [I'm 6ft 4ins....my hands are a tad large] but there's obviously some logic there.
And more importantly....it works for them. Although I'm still trying to figure out what sort of small furry animal Gade has stuck on the end of his racket!
I'm only suggesting that there are more than one way to do it, and often 'neatness' has little to do with functionality.
I mean, grab a piece of clay and squeeze it. The end result is not particularly 'neat' is it?
11-06-2009, 02:58 AM #16
11-06-2009, 04:36 AM #17
As for Gade, he uses very thick towelgrip and makes a slight bulge at the end (like a baseball bat, taufik does the same). So the thick grip dents in after a bit of use) So after a while he has a thick and, and thick top, and small middle part... almost the opposite
By the way, I used Karakal's PU for a while, if you wrap it with more than the 1/8th overlap you get those ridges, don't these drive you insane? I got fed up with them
By faris azmi in forum GripReplies: 10: 04-09-2012, 03:26 AM
By Slacker in forum Market PlaceReplies: 6: 03-30-2012, 12:36 PM
By taneepak in forum GripReplies: 74: 06-08-2008, 12:44 AM
By doodoo in forum GripReplies: 8: 02-28-2004, 09:14 AM
By hong in forum GripReplies: 4: 05-22-2003, 11:44 PM