Custom-Made Stringing Machine Parts

[llpjlau]

Does anybody if custom side supports are "needed" for a Pro's Pro TX700 machine?
I'm currently using a Klippermate m140 but would like to upgrade to an electronic machine (6 mounts is always better than the mere 2 on the Klippermate too). If I do upgrade, I wanna make sure I do everything the best I can so if it means upgrading the side supports then that's what I will do.

[wirre]

They look very much like the K-supports I have on my Premium Stringer 3600. I have managed to string almost 40 rackets but it is a PITA with some shared holes and sometimes I've had to risk it and loosen up the side supports (against standard stringing recommendation).

However I have now decide enough is enough and today (!) I will order Michal Sudek supports.


YMMV / mats

[Benito]

Why do you not use the small side of your Premium Stringer 3600 supports. I use them, they work quite well even if they are not large enough (a problem for tension around 13kg as the support tend to damage the racket)