Results 1 to 4 of 4
12-14-2010, 02:41 PM #1
How to wrap towel grip up the cone?
I just don't succeed in wrapping towel grip up to the cone, somehow I get like very much air beneath it :S. Thanks in advance.
Btw, it's for a Voltric 70 and a AT900T
12-14-2010, 03:23 PM #2
try cutting into the grip a bit, standard is 3cm wide or so, make it 2,5-2cm. I cut from the "bottom" end, but from the "top" should work as well.
And try to pull it tight (but don't tear it apart)
12-16-2010, 10:03 PM #3
I agree with jerby about trimming down the grip a little. I actually trim on both sides so only the middle with the sticky tapes are left. Also helps you work the grip a little more.
12-24-2010, 05:38 PM #4
Like Jerby said, just pull it nice and tight, and take your time with it, to get the best results.
By Wilson Shuttler in forum Malaysia Professional PlayersReplies: 8: 06-27-2013, 12:44 PM
By Sandmann in forum GripReplies: 2: 04-22-2010, 10:38 AM
By TheHalfAMan in forum GripReplies: 4: 03-22-2010, 07:09 PM
By Inconsistent in forum GripReplies: 22: 01-01-2010, 08:32 PM
By fishmilk in forum GripReplies: 13: 07-15-2004, 07:44 PM