How to wrap towel grip up the cone?

Discussion in 'Grip' started by Dokkie, Dec 14, 2010.

  1. Dokkie

    Dokkie Regular Member

    Joined:
    Jun 6, 2009
    Messages:
    481
    Likes Received:
    0
    Location:
    The netherlands
    I just don't succeed in wrapping towel grip up to the cone, somehow I get like very much air beneath it :S. Thanks in advance.

    Btw, it's for a Voltric 70 and a AT900T
     
  2. jerby

    jerby Regular Member

    Joined:
    Sep 3, 2005
    Messages:
    4,123
    Likes Received:
    32
    Location:
    EU
    try cutting into the grip a bit, standard is 3cm wide or so, make it 2,5-2cm. I cut from the "bottom" end, but from the "top" should work as well.
    And try to pull it tight (but don't tear it apart)
     
  3. weeyeh

    weeyeh Regular Member

    Joined:
    Nov 20, 2005
    Messages:
    1,646
    Likes Received:
    4
    Location:
    Singapore
    I agree with jerby about trimming down the grip a little. I actually trim on both sides so only the middle with the sticky tapes are left. Also helps you work the grip a little more.
     
  4. LD rules!

    LD rules! Regular Member

    Joined:
    Apr 3, 2009
    Messages:
    2,306
    Likes Received:
    235
    Location:
    Earth
    Like Jerby said, just pull it nice and tight, and take your time with it, to get the best results.
     

Share This Page