Results 1 to 10 of 10
Thread: 1st Gen Ti10
12-15-2010, 03:07 AM #1
1st Gen Ti10
hey, need a quick advise...i bought a second hand Ti10 1st gen...
after i take home only i realise is IP code at the cone
but the racket printed SP version
is the old 1st gen racket SP version but coded with IP?
if need the full code, i can provide tomorrow. thanks.....
12-15-2010, 12:29 PM #2
Pics/codes would help, but IP code can be SP on the racket.
12-15-2010, 01:11 PM #3
yes it could be IP + SP on the shaft, it is exactly the same as mine. but again, pictures would be helpful and check your serial on the serial post
12-18-2010, 01:09 AM #4
pics please.. curious to see..
12-18-2010, 05:50 AM #5
I remember a thread saying that the IP code was for distribution anywhere and that it did not stand for International Player. So I guess it is possible to have an IP on a SP racket.
12-22-2010, 08:50 PM #6
here is the photos....sorry as the code is blur, due to few factors phone camera and also
the printing also faded as the racket should be quite old....
shaft code 4981847
cone code 110647IP
12-22-2010, 08:58 PM #7
Oh no it is a fake... omg nooo.... =P
12-22-2010, 09:38 PM #8
12-23-2010, 07:38 AM #9
12-23-2010, 12:30 PM #10
No problem with the shaft and cone code numbers in any case ...
By MendyHoltzman in forum Buy & Sell - Read the rules sticky before you postReplies: 5: 04-29-2010, 01:15 PM
By Hanz6668 in forum Buy & Sell - Read the rules sticky before you postReplies: 1: 06-19-2009, 03:02 AM
By Fladyz in forum Buy & Sell - Read the rules sticky before you postReplies: 3: 06-11-2009, 09:35 PM
By gjz24 in forum Market PlaceReplies: 2: 07-14-2005, 07:19 PM
By |R|S in forum Racket Recommendation / ComparisonReplies: 0: 06-12-2002, 09:49 AM