Arcsaber Z slash and Nanospeed ; bad or not so bad?

Discussion in 'Broken Rackets' started by eng n chin, Feb 6, 2011.

  1. eng n chin

    eng n chin Regular Member

    Joined:
    Feb 20, 2006
    Messages:
    33
    Likes Received:
    0
    Occupation:
    student
    Location:
    shepperton
    hi all,

    just wondering what everyone thinks of my 2 rackets. the Z has a chip which i got at th beginning of th session( which i smashed quite a lot it) couldnt feel it but there IMG_0902.jpg IMG_0910.jpg IMG_0908.jpg IMG_0911.jpg IMG_0907.jpg IMG_0912.jpg IMG_0905.jpg IMG_0909.jpg IMG_0906.jpg is one layer of paint + graphite tht is lifted from th rest of th racket. couldnt feel it but...

    the 9900 has a chip missing, whicht h photo cant pick up. no thicker then a nail but it's 1mm deep and about 4mm long. the point where the cone meets th shaft has a funny tapping sound wen i make small swings as well. dont remember it playing badly. is it a goner????
     
  2. Avenger

    Avenger Regular Member

    Joined:
    Nov 27, 2010
    Messages:
    538
    Likes Received:
    14
    Occupation:
    Student
    Location:
    Indonesia
    from the picture, I think your rackets are fine
    but you need to check it again, are there any hairline cracks? (check it, because we cannot really see it here)
    if there is no crack or hairline cracks, it's fine then

    for the cone, I'm not really sure
    maybe you can post the pic of the cone?
     
  3. eng n chin

    eng n chin Regular Member

    Joined:
    Feb 20, 2006
    Messages:
    33
    Likes Received:
    0
    Occupation:
    student
    Location:
    shepperton
    there are no cracks on th arc, th pics make it look much worst thn wht it really is. th cone has tiny bits of paint missing from th top but no gap like others have posted. also, th sound only occurs wen i swing tht racket side to side. is tht bad?
     

Share This Page