Replacement grip installation method

Discussion in 'Grip' started by txv611, Feb 18, 2011.

  1. txv611

    txv611 Regular Member

    Joined:
    Nov 20, 2010
    Messages:
    241
    Likes Received:
    2
    Location:
    SG
    1. Do u guys prefer to wrap the grip such that there is very little overlapping to make it very flat even surface? ie. 2 mm overlapping.

    OR

    2. Overlap it such that you get multiple overlapping bumps throughout the entire handle for more friction? ie. 8 mm overlapping.


    Would u use a lot of overlapping to fatten it to your desired size or use multiple flat layers with method 1 to fatten yet a flat and smooth contour grip?
     
  2. monticore

    monticore Regular Member

    Joined:
    Dec 14, 2010
    Messages:
    96
    Likes Received:
    1
    Location:
    ontario
    i use number 2, unless the ridges get too big then i would use a flat replacement grip + overgrip t'ill i got the proper grip size. i prefer a single grip if possible since i i don;t want to increase the handle weight too much.


    cory
     

Share This Page