lethal 50 racket head slightly bend . is it normal?

Discussion in 'Badminton Rackets / Equipment' started by blackcaz, Mar 14, 2011.

  1. blackcaz

    blackcaz Regular Member

    Joined:
    Feb 10, 2011
    Messages:
    9
    Likes Received:
    0
    Occupation:
    -
    Location:
    malaysia
    i have recently bought a apacs lethal 50 and string it at 27-28lbs . the head of the racket has a slight bend . i lay the shaft and the head on a flat surface , and notice that 1 side's gap is slightly bigger than the other side . please advice me thank you .
     
    #1 blackcaz, Mar 14, 2011
  2. druss

    druss Regular Member

    Joined:
    Sep 19, 2009
    Messages:
    1,685
    Likes Received:
    37
    Location:
    Edmonton, AB
    Who strung it? if you cut the strings and it goes back to normal then pretty sure it was the stringers fault.
     
    #2 druss, Mar 14, 2011
  3. blackcaz

    blackcaz Regular Member

    Joined:
    Feb 10, 2011
    Messages:
    9
    Likes Received:
    0
    Occupation:
    -
    Location:
    malaysia
    string it from the same shop that i bought the racket from . i should cut the string ?
     
    #3 blackcaz, Mar 14, 2011
  4. Koooko

    Koooko Regular Member

    Joined:
    Dec 15, 2010
    Messages:
    49
    Likes Received:
    0
    Occupation:
    Bankers
    Location:
    Penang
    show us some pictures pls.^^
     
    #4 Koooko, Mar 14, 2011
  5. druss

    druss Regular Member

    Joined:
    Sep 19, 2009
    Messages:
    1,685
    Likes Received:
    37
    Location:
    Edmonton, AB
    Where exactly is the gap? As requested, a picture is worth 1000 words.
     
    #5 druss, Mar 14, 2011
  6. blackcaz

    blackcaz Regular Member

    Joined:
    Feb 10, 2011
    Messages:
    9
    Likes Received:
    0
    Occupation:
    -
    Location:
    malaysia
    the tip of the racket bend slightly inwards . gap.jpg
     
    #6 blackcaz, Mar 14, 2011

Share This Page