Results 1 to 7 of 7
Thread: Replacing Overgrips
06-28-2011, 09:45 AM #1
I replaced an overgrip recently and while taking off the grip, the original grip was somewhat torn (got stuck on the old over grip). Does the shape of the original grip matter when applying the new overgrip?
Or, on a new racket, should there be some sort of protection applied to the original grip if the preference is to have the overgrip?
Thanks in advance.
07-08-2011, 02:34 AM #2
On new rackets...just leave the plastic on the handle intact. Place the overgrip over the plastic and that should prevent ripping the original grip when you change the overgrip.
08-17-2011, 05:20 AM #3
If use overgrip that don't have sticker also stuck with ori grip when take off?
08-17-2011, 07:02 AM #4
08-18-2011, 11:42 AM #5
Depending on the person... If you leave the plastic on, the grip size is EVER SO SLIGHTLY thicker... And you might not be absolutely comfortable with it. I had that problem with the G4 grip.... Had to remove the plastic to apply the overgrip...
08-20-2011, 05:15 AM #6
if u dont like the plastic sound, take it out and try wrap the original grip with thin 1 layer of cellophane tape. but then later will be hard if you ever want to take out the tape
08-24-2011, 11:55 PM #7
No worries, just use a pen knife and cut it. Should be ok. Don't be afraid to try new stuff. It's a adventurous journey.
By TonksShuttle in forum GripReplies: 13: 07-06-2010, 11:56 PM
By foshomo03 in forum Buy & Sell - Read the rules sticky before you postReplies: 0: 03-08-2009, 01:38 AM
By Roman00 in forum Market PlaceReplies: 5: 01-13-2007, 05:52 PM
By bdmntnbdmntn in forum GripReplies: 1: 09-03-2006, 11:34 AM
By yoyomonkey in forum GripReplies: 31: 08-20-2006, 10:11 AM