isn't that up to your preference? if you prefer it to be thicker, you can apply something on the wood first to make it thicker? i prefer to add a layer of electrical tape on the wood before applying the grip. this is to ease the process of removing the grip without leaving a lot of residue. regarding the LCW style, wait for other people's answer. i have no idea neither do i really care
Ziggy your pic looks off topic...is it LCW style ? The gripping style we are talking about here is for over grip only And the main tip is to put the over grip reverse
erm..i used the same concept i did add the extra piece of grip at the bottom and i start gripping using the broad end, not the "sharpie" end i followed Demolidor's video but because i'm using a replacement grip, the bulge at the bottom didn't seemed to be that big it does feel good though
lol... thanks mate... its a bit loose due to heavy use (due to need a new grip) Always had the 3/4 grip.. adding the bulge at the end just made it more comfortable.
That bulge the end there also from overgrip? why are u wrapping the end of the grip taufik style but above that lin dan style?
no, its not from overgrip.. and as i said, i have always wrapped up 3/4... and towelling at the bottom is to stop the plastic end rubbing onto my hand
It sure is That is why I humbly said your towel gripping reminds me most of Taufik's. A lot of people these days are totally ignoring that Taufik was the one who started with this grip style.
i believe i read a post a long time ago regarding that LD and Taufik shared the same technique or reason for the 3/4 or in ld case, 1/2 grip, however i never found a pic of THs racket (not in that close up or quality of the picture you have posted anyway ) Thanks for the picture... the gripping style isnt something i made up afterall lol.. but is infact someones elses lol..
May be I miss this part. But I still dont understand how to make the bulge like that. How do you do that? Do you start gripping from the top (cone)? Thank you..
put some extra unwanted overgrip at the bottom of it 1st.. then start gripping the racket from the bottom too
Oh, OK! Thanks! What about the TH grip? How to make the bulge? And where to start gripping? I hope Babyface can answer my question..
Hi rocker... i use a foam strip cut it in half (need 3 halves in total) and i stick them on top of each other on the bottom. then i wrap the towel grip from the bottom
Thanks for answer Babyface I will try it! But I think I will try the LCW's style first, because its easier than TH
This is mine, AT700 with TH grip style(i use AC204. AC 402 and 404 not available in Indonesia) But I've problem with the bulge.. In first picture we can see that TH covered the YY logo at bottom with the grip. But its very hard to do Any idea?