by the way i am stringing my new yonex ns9900. but since i got my klipper i cut the strings to experiment with my first experience. and unfortunately, its still not string. but i am hoping that thru your help guys i can successfully restring it.
O.O fandulan, could you maybe buy a cheap steel or aluminum racket to practice with first? I'd hate for the NS9900 to accidentally break when you string it.
but better to first do in the most expensive racket so i will be very careful doing it. ill do it for sure if you will give me a good start to begin with. really i am very serious in learning it..
hey man, I am going to post a few videos in a few days on how to string a badminton racket on a crack machine but you will be able to apply the method to your klipper M140 machine.
thanks godfather ill wait for your next post. anyway my hiqua clamps in on its way. it is really a big help.
Should be able to put them up tomorrow if more string arrives but otherwise it will be next Tuesday because i will gone to the uk.
sorry everyone no string came from stringersworld.co.uk this morning so it will come tomorrow morning but I am going to the UK at 10;30 so I'l try my best but it will be next week most likely.
when i tie off at b8 on both side of the racket. do i need to cut the string before i start with the cross. coz i tied both at b8 and im stucked.
1) is this 10 meter string from a pack or you measured it? 2) Are you using 1 piece or 2 pieces method? 3) Don't go out drinking till 8:00pm and go back to office and work till 10:30 and get back home 2:00 am and return back to work 8:00am again. It is just ....
it is on the yonex pack. can you give me detail procedure on stringing 1 piece. and for 2 pieces method how much length should i allow on the left side of the racket. thanks for your reply.
I will do my best to answer your question even I am not feeling too good right now. 1) For 1 piece, please measure 2.75~2.9 meater from one end. That should be the length for the short side. 2) for 2 pieces, please measure 5.5~5.75 meter from one end. Cut. The long one is for your main and short is for you cross...
for 1 piece method, should i follow the procedures of yonex. or will these be a contunous stringing without cutting the strings.
for 1 piece, please tie off at B8 on short side only. use the rest of the long string, go through B9 and start the cross from there.