Separate names with a comma.
The USB port is just used for calibrating the tension and by factory only. After a 2086 is assembled, has to calibrate the tension to be accurate...
Base on our badminton stringing experience, we gave our specification and asked the factory made it for us. The factory can be contacted via...
We just found a factory and asked them customized made the machine as we specified. The reason we can do this is 1. there are many stringing...
A special customized ordered stringing machine for 2086. [MEDIA] [MEDIA]
It seems to me that you like to use the swivel clamp to start the main string rather than to use the starting clamp.
Although a little complicate, but worth to try. It is very good for racket frame protection when stringing as well as playable.
Hope it might help before Kwun make a video. ftp://mail.im.tku.edu.tw/Prof_Liang/Stringing/2086%20service%20DIY.pdf
No video but pictures before Kwun can make a video, hope it might help. ftp://mail.im.tku.edu.tw/Prof_Liang/Stringing/2086%20service%20DIY.pdf
No, there is no sensor protection built. I have just repaired a 2086 with error code 3 for my friend. The code 3 error means the self test process...
This knot is not the starting knot but an ending knot. Not only the knot in the grommet is OK, but also a perfect work.
It is not C-7027 for sure. Here is the C-7027 http://www.goodchinashop.com/Productdetail/show/id/100173189 Also, the machine you post are with bar...
The stringing pattern of VT80 is just the simplest stringing pattern that preweave all the mains and crosses. Tensioning the mails from one side...
The tool is called setting off awl, for straightening the mains and the crosses when the stringing job is done.
Just mains=cross+10% won't achieve your expect. If you string on a crank machine and you hope the result strung like other constant pull...
It seems that there is no ready 6 point product for your machine. However, if you can do a little modification yourself, maybe you can try TRUMP...
Also, the 1st cross on the top seems to be missed.
Well, I like to string my racket with a little modification of Gosen 2012 professional pattern. Gosen 2012 Professional Pattern is shown follows....
You are doing the most correct way. Only when we forgot to or lazy to enlarge the shared holes before we start to string, we have to find some...
To Kwum, It depends on the shape of racket frame. For ISO shape frame, I do the following, suppose user ask for 27lb, I like to set...
Kwun, It depends on the shape of racket frame, for ISO shape frame, I do the following, the 1st to 4th main I keep the tension user asked....